Try our new documentation site (beta).
GRBCallback.AddLazy()
Add a lazy constraint to the MIP model from within a callback function.
Note that this method can only be invoked when the where
member variable is GRB.Callback.MIPNODE or GRB.Callback.MIPSOL (see the
Callback Codes section for more
information).
Lazy constraints are typically used when the full set of constraints for a MIP model is too large to represent explicitly. By only including the constraints that are actually violated by solutions found during the branch-and-cut search, it is sometimes possible to find a proven optimal solution while only adding a fraction of the full set of constraints.
You would typically add a lazy constraint by first querying the
current node solution (by calling
GetSolution from a
GRB.Callback.MIPSOL callback, or
GetNodeRel from a
GRB.Callback.MIPNODE callback), and then calling AddLazy() to
add a constraint that cuts off the solution. Gurobi guarantees that
you will have the opportunity to cut off any solutions that would
otherwise be considered feasible.
Your callback should be prepared to cut off solutions that violate any of your lazy constraints, including those that have already been added. Node solutions will usually respect previously added lazy constraints, but not always.
Note that you must set the LazyConstraints parameter if you want to use lazy constraints.
| void | AddLazy ( | GRBLinExpr | lhsExpr, |
| char | sense, | ||
| double | rhsVal ) |
-
Arguments:
lhsExpr: Left-hand side expression for new lazy constraint.
sense: Sense for new lazy constraint (GRB.LESS_EQUAL, GRB.EQUAL, or GRB.GREATER_EQUAL).
rhsVal: Right-hand side value for new lazy constraint.
| void | AddConstr ( | GRBTempConstr | tempConstr ) |
Arguments:
tempConstr: Temporary constraint object, created by an overloaded comparison operator.
