Try our new documentation site (beta).
PStart
| Type: | double |
|---|---|
| Modifiable: | Yes |
The current simplex start vector. If you set PStart values
for every variable in the model and
DStart values for every
constraint, then simplex will use those values to compute a warm start
basis. If you'd like to retract a previously specified start, set any
PStart value to GRB_UNDEFINED.
Note that any model modifications which are pending or are made after
setting PStart (adding variables or constraints, changing coefficients, etc.)
will discard the start. You should only set this attribute after you are
done modifying your model.
Note also that you'll get much better performance if you warm start
your linear program using a simplex basis (using
VBasis and
CBasis). The PStart
attribute should only be used in situations where you don't have a
basis or you don't want to disable presolve.
If you'd like to provide a feasible starting solution for a MIP model, you should input it using the Start attribute.
Only affects LP models; it will be ignored for QP, QCP, or MIP models.
Note that if you provide a valid starting extreme point, either through PStart, DStart, or through VBasis, CBasis, then LP presolve will be disabled by default. For models where presolve greatly reduces the problem size, this might hurt performance. For presolve to be enabled, the parameter LPWarmStart must be set to 2.
For examples of how to query or modify attributes, refer to our Attribute Examples.
